Thank you! Message Sent!
ERROR: Message Not Sent!
*Name


*Email


Phone


*Question


Download PDF of this page  Print this page

Workpiece Speed & Direction - Tool Post Grinders

For cylindrical tool post grinding, the usual work speed range is 50 to 90 sfm. Typically, a work speed of about 50 rpm works well for most grinding operations. However, this speed can be varied to meet many grinding conditions.

If the grinding wheel glazes (the grains dull before the bond wears), the wheel is too “hard” for conditions. A reasonable variation in apparent wheel grade can be compensated by varying work speed. By increasing the workpiece rpm, the wheel will provide a “softer” action because it must now remove more material per wheel revolution. This increases the cutting force per grain, so the grains are more readily broken off, thus exposing new sharp grains and keeping the wheel from glazing.

Conversely, a grinding wheel that is loading (bond wears before grain dulls) is too “soft” for conditions. This can be remedied to some degree by decreasing speed, so the wheel cuts less material per wheel revolution. As a result, the grains are less readily lost, making the wheel seem “harder”.

External grinding is done with the work rotating in the same direction as the grinding wheel, while internal grinding is done with the work rotating in the opposite direction. In both cases, the result is the contact faces of the work and wheel moving in opposite directions, thus maximizing cutting action.